![]() ![]() If your watch requires cleaning, lubrication, battery changing, or needs a crystal replaced, Armitron Adventure approved Service Centers are available in your area. YOU CANNOT RETURN WATCH FOR SERVICE WHERE IT WAS PURCHASED. Water can corrode electronic parts inside the case. Should water or condensation appear in the watch, immediately have the watch checked. Do not operate push buttons below the surface of the water. It is recommended that you bring your timepiece to a local jeweler. However, it is not necessary to return your watch to the manufacturer for battery replacement. This watch contains precise electronic components and should only be opened by a qualified watch technician. ![]() Replace with the same kind or equivalent only. Before removing the old battery, be sure to denote its polarity so that the new battery is installed in exactly the same way. CHANGING THE BATTERYĬhange the battery when the watch becomes slow, the readout darkens or does not appear, or the backlight fails. Press ‘B’ to return to Time Telling Mode. When the Timer has expired, the alarm will sound for about 10 seconds or until any button is pressed. NOTE: The Countdown timing will continue in any mode until ‘C’ is pressed. Press ‘C’ again to resume the Countdown Timer. If desired, press ‘C’ again to stop the Countdown Timer.Press ‘C’ to start the Countdown Timer.When the Countdown Timer is set, press ‘A’ to end set sequence and return to Timer Mode.From Time Telling Mode, press ‘B’ three times to enter the Timer Mode.NOTE: The Second Time (Second Time Zone) Clock may be used to keep track of a foreign time. Press ‘B’ to return to Time Telling Mode.From Time Telling Mode, press ‘B’ four times to enter the Second Time Zone Mode.Press ‘B then press ‘C’ to activate or deactivate the selected Alarm.If the Weekly Alarm is selected, press ‘B’ then press ‘C’ to select the Day of the Week. Press ‘C’ to select either the Daily (DA) or the Weekly (WE) Alarm. Press ‘B: Daily or Weekly Alarms flash.Press ‘C’ to select either Normal Time (Ti) or Dual Time (T2) Alarm. Press ‘C’ to select the Alarm Number (Al-A3). From Time Telling Mode, press ‘B’ twice to enter the Alarm Mode.When the Hourly Chime is activated, the Hourly Chime will sound with one “Beep” every hour on the hour. When the Alarm is activated, the selected Alarm will sound at the preset Alarm Time for 20 seconds or until any button is pressed. “ON” indicates that the “Beep” will sound. NOTE: The Alarm or Chime Symbols appear when the Alarm and Hourly Chime are activated. Press ‘C’ to activate or deactivate the selected Alarm, Hourly Chime, or “Beep” sound.While in Alarm Mode, press ‘A’ to select the Alarm (A1-A3), Hourly Chime (CH), and “Beep” sound (BP).Press ‘A’ to reveal the final Split Time. Press ‘C’ to stop timing at the end of the event. Press ‘A’ to measure and display Split Times. While in the Stopwatch Mode, press ‘C’ to start timing 2.From Time Telling Mode, press ‘B’ once to enter the Stopwatch Mode.Press ‘A’ to end sequence and return to Time Telling Mode.NOTE: ‘121 indicates 12 Hour Format ’24’ indicates 24 Hour (Military Time). ![]() Press ‘C’ to select either 12 Hour Time or 24 Hour (Military) Time.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |